Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure for Subaru Select Monitor Communication: Inspection
Diagnosis:Â
Subaru Select Monitor communication line is open or shorted.
Trouble symptom:Â
Not communicable with Subaru Select Monitor.
Wiring diagram:Â
CAN communication system Ref. to WIRING SYSTEM>CAN COMMUNICATION SYSTEM>WIRING DIAGRAM .
- CHECK SUBARU SELECT MONITORÂ
.
- Connect the Subaru Select Monitor to another vehicle.
- Check the communication condition between Subaru Select Monitor and another vehicle.
Is the check result OK?
Yes : Go to  2.
No : Repair or replace the Subaru Select Monitor.
- CHECK DATA LINK CONNECTORÂ
.
Using a tester, check the ground circuit of the data link connector.
Connector & terminal: StandardÂ
(i221) No. 4 - Chassis ground: Less than 1 Ω
(i221) No. 5 - Chassis ground: Less than 1 Ω
Is the check result OK?
Yes : GO TO  3.
No : Repair or replace faulty parts.
- CHECK DATA LINK CONNECTORÂ
.
- Turn the ignition switch to ON.
- Using a tester, check the power supply voltage of the data link connector.
Connector & terminal: StandardÂ
(i221) No. 8 (+) - Chassis ground (-): 11 - 14 V
(i221) No. 16 (+) - Chassis ground (-): 11 - 14 V
Is the check result OK?
Yes : GO TO  4.
No : Check the power supply circuits to the data link connector.
- CHECK COMMUNICATION FOR INITIALIZING ERRORÂ
.
Perform the communication for initializing with each module by connecting the Subaru Select Monitor. (For systems whose module can communicate with diagnostic devices)
NOTE: By performing [CAN bus connected ECU], confirmation of minimal connection modules is possible. Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN BUS CHECK .Is the communication possible with all modules?
Yes : The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.No : Perform the inspection using the check sheet of communication for initializing. Ref. to LAN SYSTEM (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE FOR SUBARU SELECT MONITOR COMMUNICATION>INSPECTION>CHECK USING THE CHECK SHEET OF COMMUNICATION FOR INITIALIZING .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
