2024 Subaru Impreza BaseFACTORY OEM SERVICE PROCEDURE

Fuel Pump Side

  1. Check that the fuel level sensor has no damage.
  2. Measure the fuel level sensor float position.
    NOTE: When inspecting the fuel level sensor, perform the work with the sensor installed to the fuel pump.
    G16760730Courtesy of SUBARU OF AMERICA, INC.
    (A)  FULL 
    (B)  EMPTY 
    (C)  Fuel tank seating surface 
    Float position  Standard 
    FULL - Fuel tank seating surface H1 187.2 - 194.2 mm (7.37 - 7.646 in)
    EMPTY - Fuel tank seating surface H2 21.1 - 28.1 mm (0.831 - 1.107 in)
  3. Check the resistance between fuel level sensor terminals by the connector on top of the fuel pump.
    G16760731Courtesy of SUBARU OF AMERICA, INC.
    Float position  Terminal No  . Standard 
    FULL (A) 1 - 4 7.7 - 9.7 Ω 
    EMPTY (B) 230.9 - 235.9 Ω
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.