2024 Subaru Impreza BaseFACTORY OEM SERVICE PROCEDURE

Work Support: List

Work Support item Contents Remarks
System Initialization Perform this procedure when top dead position or bottom dead position becomes misaligned or when instructed in the diagnostic procedure. With this procedure, the following data can be initialized.
  • Top dead position
  • Bottom dead position
  • Sliding resistance value
  • DTC/FFD
  • Data monitor history items
NOTE: When initialization is performed, record the DTCs and FFD because they will be erased.
-
History Clear With this procedure, the following data can be initialized.
  • Data monitor history items
-
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.