2024 Subaru Impreza BaseFACTORY OEM SERVICE PROCEDURE

Front Regulator & Motor Assembly

G16771525Courtesy of SUBARU OF AMERICA, INC.
Terminal No. Contents Measuring condition Standard
(Df51) or (Df52) No. 1 ←→ Chassis ground GND Always Less than 1 Ξ©
(Df51) or (Df52) No. 2 - Β  Β 
(Df51) or (Df52) No. 3 ←→ Chassis ground SW assembly PW SUB LED output (Passenger's side only) Power window switch LED light: ON Battery voltage
Power window switch LED light: OFF 10 ΞΌA or less
(Df51) or (Df52) No. 4 SW assembly PW AUTO operation input (Passenger's side only) Power window switch AUTO: ON 1.0 V or less
Power window switch AUTO: OFF Battery voltage
(Df51) or (Df52) No. 5 ←→ Chassis ground Power supply for regulator Always Battery voltage
(Df51) or (Df52) No. 6 ←→ Chassis ground SW assembly PW DOWN operation input Power window switch DOWN: ON 1.0 V or less
Power window switch DOWN: OFF Battery voltage
(Df51) or (Df52) No. 7 UP and DOWN LIN signal input - -
(Df51) or (Df52) No. 8 ←→ Chassis ground SW assembly PW UP operation input Power window switch UP: ON 1.0 V or less
Power window switch UP: OFF Battery voltage
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.