2024 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Select Cable: Installation

CAUTION:
  • Check that the protector (b) is set between the clamps (a).
  • If the protector (b) is offset, set it between the clamps (a).
G13935596Courtesy of SUBARU OF AMERICA, INC.
  1. Install the select cable to cable plate.
    CAUTION: Be careful not to twist the boot.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb)

    G13225512Courtesy of SUBARU OF AMERICA, INC.
  2. Set a new clamp on the select lever and secure it by bending the claw.
    G00675463Courtesy of SUBARU OF AMERICA, INC.
    (A) Front side
    (B) Upside
  3. Install the select cable to the select lever. (If the connector pin is not removed)
    CAUTION:
    • Install the cable so that it does not twist.
    • Check that the select lever is in "N range".
    • If the connector pin is removed, always replace with a new connector pin.
    • Do not apply excessive load while holding the part (a).
    G14602404Courtesy of SUBARU OF AMERICA, INC.
    1. Insert the select cable to the connector pin.
    2. Secure the select cable to the clamp.
    G14602410Courtesy of SUBARU OF AMERICA, INC.
  4. Install the select cable to the select lever. (If the connector pin is removed)
    CAUTION:
    • Install the cable so that it does not twist.
    • Check that the select lever is in "N range".
    • Do not apply excessive load while holding the part (a).
    G14602404Courtesy of SUBARU OF AMERICA, INC.
    1. Secure the select cable to the clamp.
    2. Align the cable thread with the select lever arm.
      G00675464Courtesy of SUBARU OF AMERICA, INC.
    3. Install a new connector pin.
      G00675465Courtesy of SUBARU OF AMERICA, INC.
  5. Temporarily Install the adjusting nut (rear) to the select cable.
  6. Apply grease to the shifter arm.

    Preparation items: 

    Grease: NIPPON GREASE NIGTIGHT LTS No. 2 or equivalent

    G16387247Courtesy of SUBARU OF AMERICA, INC.
  7. Connect the select cable to the transmission main body.
    CAUTION: Do not apply excessive load while holding the part (a).
    G13591814Courtesy of SUBARU OF AMERICA, INC.
Chapter Navigation
Return to Chapter: Select Cable
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.