2024 Subaru Crosstrek BaseFACTORY OEM SERVICE PROCEDURE

Select Lever: Installation

  1. Install the select cable to the select lever. Ref. to CONTROL SYSTEMS>SELECT CABLE>INSTALLATION .
  2. Install the select lever.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb)

  3. Install the clip securing the harness.
  4. Connect the connector.
    G16767434Courtesy of SUBARU OF AMERICA, INC.
  5. Install the cover center side. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CONSOLE>INSTALLATION .
  6. Install the console box. Ref. to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>INSTALLATION .
  7. Install the clamp to the grip.
    NOTE: Insert it from the front side.
  8. Install the cover grip AT to the grip. (Model with gate shifter)
  9. Install the grip to the select lever.
    NOTE: For the model with boot shifter, install it while pressing on the clamp.
  10. Install the boot to the grip. (Model with boot shifter)
  11. Shift the select lever to "P range".
    1. Press the shift lock release button.
    2. Shift the select lever to "P range".
  12. Install the wireless charger assembly. (Model with wireless charger) Ref. to ENTERTAINMENT & MONITORING>WIRELESS CHARGER>INSTALLATION .
  13. Install the mat tray center. (Model without wireless charger)
  14. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Chapter Navigation
Return to Chapter: Select Lever
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.