2024 Subaru BRZ tSFACTORY OEM SERVICE PROCEDURE

Select Lever

  1. Temporarily install the select lever.
  2. Tighten the bolts in the numerical order as shown in the figure.

    Tightening torque:

    18 N.m (1.8 kgf-m, 13.3 ft-lb)

    Fig 1: Select Lever Bolts Tightening Sequence
    G16525439Courtesy of SUBARU OF AMERICA, INC.
  3. Install the clip securing the harness.
  4. Connect the connector.
  5. Adjust the select lever. Ref. to CONTROL SYSTEMS>SELECT LEVER>ADJUSTMENTΒ .
  6. Install the cover center side and the console box assembly. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CONSOLE>INSTALLATION .
  7. Install the grip by turning it clockwise.
    NOTE:
    • Tighten to the extent where the grip does not rotate during shift operation.
    • Align the grip notch (a) toward the rear of the vehicle while turning in the tightening direction.
    G16525440Courtesy of SUBARU OF AMERICA, INC.
  8. Install the boot.
  9. Release the shift lock using a screwdriver, etc. and shift the select lever to the "P range".
    G16525441Courtesy of SUBARU OF AMERICA, INC.
  10. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.