Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE
Fuel Injector: Inspection
- Check that the fuel injector has no deformation, cracks or other damages.
- Measure the resistance between fuel injector terminals.NOTE: This inspection can be used for judgment on short circuit or open circuit among the causes of faulty operation.
| Terminal No. | Standard |
|---|---|
| 1 - 2 | Port injection side: Approx. 12 Ω (at 20°C (68°F)) Cylinder direct injection side: Approx. 1.89 Ω (at 20°C (68°F)) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.