2024 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE

Fuel Filler Pipe: Installation

NOTE: For the installation procedure of fuel filler lid, refer to "Fuel Lid". Ref. to SECURITY AND LOCKS>FUEL LID>INSTALLATION .
  1. Open the fuel filler lid.
  2. Insert the fuel filler pipe into the ring clip from inside of the rear fender.
  3. Install the nut securing the fuel filler pipe.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

    G16523426Courtesy of SUBARU OF AMERICA, INC.
  4. Install the bolt securing the fuel filler pipe.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  5. Connect the drain tube (C), circulate tube (B) and fuel filler hose (A).

    Drain tube: 

    Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION>QUICK CONNECTOR CONNECTION (TYPE G) .

    Circulate tube: 

    Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION>QUICK CONNECTOR CONNECTION (TYPE D) .

    Fuel filler hose: 

    Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION>FUEL FILLER HOSE CONNECTION .

    G16523425Courtesy of SUBARU OF AMERICA, INC.
  6. Install the mud guard rear RH. Ref. to EXTERIOR/INTERIOR TRIM>MUD GUARD>INSTALLATION .
  7. Install the rear suspension assembly. Ref. to REAR SUSPENSION>SUB FRAME>INSTALLATION .
  8. Install the fuel filler pipe protector.
  9. Install the fuel filler cap, and close the fuel filler lid.
Chapter Navigation
Return to Chapter: Fuel Filler Pipe
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.