Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE
Fuel Filler Pipe: Assembly
- Using a new neck holder, assemble the fuel filler pipe. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>GENERAL DESCRIPTION>COMPONENT>FUEL FILLER CAP AND FUEL FILLER PIPE .NOTE: Install the bracket to the fuel filler pipe by aligning it with the alignment mark (a).
- Attach cushion to the fuel filler pipe. (When replacing with a new part)NOTE:
- Before attaching the cushion, degrease the attachment area of fuel filler pipe.
- Attach the cushion to the range (a) as shown in the figure.
- Attach the cushion so that it is parallel to the bracket (b).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.