2024 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

Reverse Brake: Disassembly

  1. Remove the snap ring, and then remove the retaining plate, drive plate, driven plate and dish plate.
    G00679071Courtesy of SUBARU OF AMERICA, INC.
    (A) Snap ring
    (B) Retaining plate
    (C) Drive plate
    (D) Driven plate
    (E) Dish plate
    (F) Intermediate case
  2. Compress the return spring using the ST and a press to remove the snap ring.

    Preparation tool:Β 

    ST: COMPRESSOR SPECIAL TOOL (18762AA001)

    G13622152Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the spring retainer and return spring.
    G00679072Courtesy of SUBARU OF AMERICA, INC.
    (A) Spring retainer
    (B) Return spring
    (C) Intermediate case
  4. Blow compressed air through the hole shown in the figure, and remove the reverse brake piston.
    G00679073Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.