Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE
Primary Pressure Sensor: Installation
CAUTION:
If water or oil contacts the connector terminal of primary pressure sensor, replace it with a new part.
- Install a new O-ring.NOTE: Apply CVTF to the O-rings.
- Install the primary pressure sensor and connect the connector.
Tightening torque:
13 N.m (1.3kgf-m, 9.6ft-lb)
- Install the transmission body.CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>TRANSMISSION ASSEMBLY>INSTALLATION
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.