2024 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

Drive Pinion: Assembly

  1. Install the plugs with new O-rings.
    NOTE: Apply CVTF to the O-rings.

    Tightening torque:Β 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

    G13622314Courtesy of SUBARU OF AMERICA, INC.
  2. Using the ST, install the oil seal.
    NOTE:
    • Apply CVTF to the press-fitting area.
    • Make sure to install in the right direction.

    Preparation tool:Β 

    ST: INSTALLER (20099AE020)

    • Pulley side
      G14611492Courtesy of SUBARU OF AMERICA, INC.
    • Front differential side
      G14611493Courtesy of SUBARU OF AMERICA, INC.
  3. Select the drive pinion shim.
    1. Using the ST and a micrometer, measure the dimension "H1" from the ST end face to the drive pinion (gear portion) end face.

      Preparation tool:Β 

      ST: GAUGE (499575600)

      G16389844Courtesy of SUBARU OF AMERICA, INC.
      (A) Measurement surface
    2. Using the ST and a press, press-fit a new taper roller bearing inner race (front side).

      Preparation tool:Β 

      ST: INSTALLER (499277200)

      G13622319Courtesy of SUBARU OF AMERICA, INC.
    3. Using a press, press-fit a new taper roller bearing outer race (A) and a new taper roller bearing (rear side) (B).
      CAUTION: Apply differential gear oil to the roller part of taper roller bearing, and rotate it 20 times or more.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.