Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE
MULTIVIEW Control Module
- Install the multiview control assembly.
- Install the center information display assembly. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY>ASSEMBLY .
- Install the grille ventilation assembly center. Ref. to AIR CONDITIONER>AIR VENT GRILLE>INSTALLATION>CENTER GRILLE ASSEMBLY .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- When the multiview control assembly has been replaced, perform the following procedures.
- Except for 4-camera model
- Using the Subaru Select Monitor, select [Carrying over Calibration data when replacing the Camera ECU] in [Work Support] of [Front & Side Camera/Multi View Monitor]. Ref. to COMMON (DIAGNOSTICS)>CUSTOMIZE>OPERATION > SAVE SETTINGS / READ SETTINGS
- 4-camera model
- Turn the ignition switch from OFF to ON, and keep this position for 2 seconds before turning the ignition switch to OFF. Turn the ignition switch to ON again.
- Using Subaru Select Monitor, select [Carrying over Calibration data when replacing the Camera ECU] in [Work Support] of [Front&Side Camera/Multi View Monitor], and perform the operation according to the display screen. Ref to 360-DEGREE SURROUND VIEW MONITOR/MULTI VIEW MONITOR (DIAGNOSTICS)>WORK SUPPORTNOTE: Data transfer is a procedure to write the automatically backed up calibration data of each camera in a new multiview control assembly.
- Read the [Front&Side Camera/Multi View Monitor] customizing information. Ref. to COMMON (DIAGNOSTICS)>CUSTOMIZE>OPERATION > SAVE SETTINGS / READ SETTINGS
- Except for 4-camera model
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.