2023 Subaru WRX Base, Standard TransFACTORY OEM SERVICE PROCEDURE

MT Gear Shift Cable: Installation

CAUTION: Do not bend the MT gear shift cable more than necessary.
  1. Install the shift bracket.

    Tightening torque:Β 

    18 N.m (1.8 kgf-m, 13.3 ft-lb)

  2. Apply grease to the shift lever COMPL.

    Preparation items:Β 

    Grease: NIPPON GREASE NIGTIGHT LTS No. 2 or equivalent

    G14602437Courtesy of SUBARU OF AMERICA, INC.
  3. Install the MT gear shift cable.
    CAUTION:
    • Do not twist the cable inner more than necessary.
    • Do not apply excessive load while holding the part (a).
    G14602434Courtesy of SUBARU OF AMERICA, INC.
    NOTE: Install the MT gear shift cable with the mark (a) on the cable facing upward.
    G14602439Courtesy of SUBARU OF AMERICA, INC.
  4. Install the snap pin and washer.
  5. Install the clamp.
    CAUTION: Do not hit the MT gear shift cable.
    If you hit the MT gear shift cable by mistake, replace it with a new one.
  6. Install the dust cover.

    Tightening torque:Β 

    15 N.m (1.5 kgf-m, 11.1 ft-lb)

  7. Install the cable clamp.
    NOTE: Pass the MT gear shift cable and MT gear select cable through the cable clamp before installing it.

    Tightening torque:Β 

    18 N.m (1.8 kgf-m, 13.3 ft-lb)

  8. Install the transmission body. Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (TY75)>TRANSMISSION ASSEMBLY>INSTALLATION .
  9. Check that the MT gear shift lever can be shifted into each position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.