Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Subaru WRX Base, Standard TransFACTORY OEM SERVICE PROCEDURE
Engine Oil Temperature Sensor: Inspection
- Check that the engine oil temperature sensor has no deformation, cracks or other damages.
- Immerse the engine oil temperature sensor and a thermometer in water.CAUTION: Take care not to allow water to get into the engine oil temperature sensor connector.
Completely remove any water inside.(A) Thermometer (B) Engine oil temperature sensor (C) Hexagonal part height: To approx. 1/3 - Raise water temperature gradually, measure the Ω between the engine oil temperature sensor terminals when the temperature is 20°C (68°F) and 80°C (176°F).NOTE: Agitate the water for even temperature distribution.
| Water temperature | Terminal No. | Standard |
|---|---|---|
| 20°C (68°F) | 1 - 2 | 2.25 - 2.65 kΩ |
| 80°C (176°F) | 0.30 - 0.331 kΩ |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.