2023 Subaru WRX Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Suspension Control Module: Removal

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Prior to starting work, check "Precautions" in the "SEATS" article. Ref. to SEATS>GENERAL DESCRIPTION>CAUTION .
  2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  3. Remove the front seat LH. Ref. to SEATS>FRONT SEAT>REMOVAL .
  4. Remove the damper control module.
    1. Remove the nut and harness clip.
      G14601773Courtesy of SUBARU OF AMERICA, INC.
    2. Disconnect the connector and remove the damper control module.
    G14601774Courtesy of SUBARU OF AMERICA, INC.
  5. Release the claws, and remove the bracket damper control module.
    G14601775Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.