2023 Subaru WRX Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Data Communication Module

  1. Install the backup battery. Ref. to ENTERTAINMENT & MONITORING>DATA COMMUNICATION MODULE>INSTALLATION>BACKUP BATTERYΒ .
  2. Install the data communication module and connect the cable CCM connector.
    CAUTION: Never install a data communication module from another vehicle. It may disable recognition of vehicle information and cause communication error.
  3. Install the center information display assembly. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY>INSTALLATIONΒ .
  4. Install the panel assembly center and the ornament panel mid passenger. Ref. to EXTERIOR/INTERIOR TRIM>CENTOR CLUSTER>INSTALLATION .
  5. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  6. Perform the registration if the data communication module is replaced with a new part. Ref. to ENTERTAINMENT & MONITORING>TELEMATICS SYSTEM>OPERATIONΒ .
  7. Check the LED illumination status of the telematics button. Ref. to TELEMATICS SYSTEM (DIAGNOSTICS)>CHECK LIST FOR INTERVIEW>CHECK>LED ILLUMINATION STATUS LIST .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.