Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Subaru Outback WildernessFACTORY OEM SERVICE PROCEDURE
Converter Case Cover: Removal
- Remove the drive pinion. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>DRIVE PINION>REMOVAL .
- Remove the primary speed sensor. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>PRIMARY SPEED SENSOR>REMOVAL .
- Remove the oil stopper plate (A) and lubrication pipe (B).
- Remove the oil pump chain cover and the oil pump chain. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>OIL PUMP CHAIN>REMOVAL .
- Remove the bolts securing the converter case cover.
- Using a crowbar wrapped with protection tape or similar, expand the clearance and remove the converter case cover.
- Remove the O-rings.
- Remove the front reduction drive gear shim.NOTE: The front reduction drive gear shim may remain on the converter case side.
- Remove the front reduction driven gear shim (front side).
- Remove the ball bearing using the ST1 and ST2.
Preparation tool:
ST1: PULLER ASSY (398527700)
ST2: CLAW (18760AA000)
- Remove the front reduction driven gear shim (front side).
- Remove the ball bearing using the ST1 and ST2.
- Remove the seal rings.
- Remove the liquid gasket from the converter case and converter case cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
