Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Wheel Alignment: Inspection: Camber
- Place the tires on the turning radius gauge.NOTE: Make sure that the ground contact surfaces of the front tires and rear tires are at the same level.
- Set the alignment gauge adapter into the center of wheel, and then set the alignment gauge.
(a) Alignment gauge (b) Turning radius gauge (c) Alignment gauge adapter - Measure the camber angle in accordance with the operation manual for alignment gauge.
Model Front camber (difference between RH and LH 45' or less) Rear camber (difference between RH and LH 45' or less) Sedan model -0°05'±0°45' -1°30'±0°45' OUTBACK model 0°00'±0°45' -1°00'±0°45' WILDERNESS model 0°15'±0°45' -0°40'±0°45'
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
