2023 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Remote Control Mirror Switch: Inspection

  1. Check the resistance between switch door mirror terminals.
    G12398790Courtesy of SUBARU OF AMERICA, INC.
    • Model without seat position memory
      • Changeover switch RH
        Terminal No. Inspection conditions Standard
        12 - 1
        12 - 18
        OFF 1 MΩ or more
        12 - 18
        17 - 1
        UP Less than 1 Ω
        12 - 17
        18 - 1
        DOWN Less than 1 Ω
        12 - 16
        18 - 1
        LEFT Less than 1 Ω
        12 - 18
        16 - 1
        RIGHT Less than 1 Ω
      • Changeover switch LH
      Terminal No. Inspection conditions Standard
      12 - 1
      12 - 21
      OFF 1 MΩ or more
      12 - 20
      21 - 1
      DOWN Less than 1 Ω
      12 - 21
      20 - 1
      UP Less than 1 Ω
      12 - 19
      21 - 1
      LEFT Less than 1 Ω
      12 - 21
      19 - 1
      RIGHT Less than 1 Ω
    • Model with seat position memory
      • Changeover switch RH
        Terminal No. Inspection conditions Standard
        12 - 1
        12 - 21
        OFF 1 MΩ or more
        12 - 21
        17 - 1
        UP Less than 1 Ω
        12 - 17
        21 - 1
        DOWN Less than 1 Ω
        12 - 16
        21 - 1
        LEFT Less than 1 Ω
        12 - 21
        16 - 1
        RIGHT Less than 1 Ω
      • Changeover switch LH
        Terminal No. Inspection conditions Standard
        12 - 1
        12 - 21
        OFF 1 MΩ or more
        12 - 21
        20 - 1
        UP Less than 1 Ω
        12 - 20
        21 - 1
        DOWN Less than 1 Ω
        12 - 19
        21 - 1
        LEFT Less than 1 Ω
        12 - 21
        19 - 1
        RIGHT Less than 1 Ω
      • Folding switch
        Terminal No. Inspection conditions Standard
        12 - 5
        4 - 1
        Retraction Less than 1 Ω
        12 - 4
        5 - 1
        Unfolding Less than 1 Ω
  2. Apply battery voltage between the switch door mirror terminals to check lighting condition of illumination inside the switch.
    CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.