Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Procedure A
- Turn the ignition switch to ON.
- Operate the driver's side, passenger's side, rear right or rear left power window switch and hold the manual down operation, or hold the automatic down operation to fully open the relevant window. Continuously from that point, hold the switch for longer than one second.NOTE:
- Wherever the glass is at any position, operate the switch in "DOWN" direction.
- For initialization for other than driver's seat, this can be done with the driver's side power window switch, or power window switch of each seat.
- Operate the driver's side, passenger's side, rear right or rear left power window switch and hold the automatic up operation to fully close the relevant window. Continuously from that point, hold the switch for longer than one second.NOTE:
- At this time, do not move the vehicle.
- For initialization for other than driver's seat, this can be done with the driver's side power window switch, or power window switch of each seat.
- Perform the automatic down operation with the driver's side, passenger's side, rear right or rear left power window switch to check whether the window fully opens properly. Also, perform the automatic up operation to check whether the window fully closes properly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
