This procedure performs settings of the following data.

NOTE:

Always perform the initialization with the vehicle parked. (Initialization cannot be operated during driving)
Perform initialization for one seat at a time.
Do not hit or apply impact or vibration to the glass, since the sliding resistance of door glass is being learned during the initialization.
Do not perform the ignition operation during the initialization.
The initialization is not required for the rear seats if the auto function is unavailable.

Perform the initialization according to the procedures by items below.

Item	Procedure
When the regulator and motor assembly is replaced with a new part	A
When the motor power supply is lost due to removing and installing of the battery terminals and the regulator & motor assembly connector during the power window operation	A
When the power window system was initialized by the Subaru Select Monitor	A
When a power window related part such as glass and running channel was replaced	B
When the phenomenon that the door glass does not close fully (incorrect reverse operation) occurred	B
When the phenomenon that the door glass does not open fully (incorrect stop operation) occurred	B

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Initial Setting: Notes