Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Central Gateway Control Module: Installation
CAUTION:
- When the central gateway Control Module has been replaced, be sure to perform the module registration.
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. (Model without keyless access with push button start)
- Except for C5 model, refer to "Type G" described in "REGISTRATION MANUAL FOR IMMOBILIZER".
- For C5 model, refer to "Type I" described in "REGISTRATION MANUAL FOR IMMOBILIZER".
- Install the central gateway Control Module.
Tightening torque:
1.8 N.m (0.2 kgf-m, 1.3 ft-lb)
- Install the speaker assembly center. Ref. to ENTERTAINMENT & MONITORING>FRONT SPEAKER>INSTALLATION .
- Install the center information display assembly and the ornament panel mid passenger. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY>INSTALLATION .
- Install the cover assembly front. Ref. to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>INSTALLATION .
- Install the grip and boot. Ref. to CONTROL SYSTEMS>SELECT LEVER>INSTALLATION .
- Install the cover center UPR or the driver monitoring unit assembly. Ref. to INSTRUMENTATION/DRIVER INFO>DRIVER MONITORING UNIT>INSTALLATION .
- Install the visor assembly. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER>INSTALLATION .
- Install the cover LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- When the central gateway Control Module has been replaced, perform the module registration. Ref. to COMMON (DIAGNOSTICS)>UNIT REGISTRATION>OPERATION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.