2023 Subaru Impreza LimitedFACTORY OEM SERVICE PROCEDURE

Work Support: Note: Notes

If the starter or TCM is replaced, always clear the start count or transfer the information of start count.

* Let the Subaru Select Monitor read "Start Count" before removing the used TCM, and then write these "Start Count" after installing a new TCM.

Preconditions for clearing the start count

  • Number of times for starting is other than 0
  • Common execution condition is established
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.