2023 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Stay Assembly Front Hood

  1. Always attach the stay assembly front hood to the normal position when performing works such as inspections and general maintenance.
    CAUTION:
    • During the inspection and general maintenance, always be sure to turn the ignition switch to OFF.
    • At the inspection and general maintenance, do not detach the stay assembly front hood.
    G16334569Courtesy of SUBARU OF AMERICA, INC.
    (1) Normal attached position
  2. When wider front hood opening is necessary, set the stay assembly front hood mounting position (front hood side) to the lower position (hinge COMPL front hood section) as shown in the figure.
G16334570Courtesy of SUBARU OF AMERICA, INC.
(1) Normal attached position
(2) Installation position at full open
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.