Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Subaru Crosstrek Base, Standard TransFACTORY OEM SERVICE PROCEDURE
Select Lever: Removal
- Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY
.NOTE: For the hybrid model, disconnect the battery negative terminal.
- Release the shift lock using a screwdriver, etc. and shift the select lever to the "N" range.
- Lower the boot assembly vertically toward the lever. (Model with boot shifter)
- Lower the cover grip AT vertically toward the lever. (Model with gate shifter)
- Remove the clamp grip pin.
- Remove the grip assembly.
- Remove the console box assembly. Ref. to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL .
- Remove the panel center LWR LH and RH. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CONSOLE>REMOVAL .
- Remove the harness clip from the select lever assembly.
- Separate the floor carpet to three layers, and cut them while staggering their cut position as shown in the figure.
- Disconnect the harness connector.
- Remove four bolts.
- Lift up the vehicle.
- Remove the rear exhaust pipe and center exhaust cover. Ref. to EXHAUST (H4DO (EXCEPT FOR HEV))>REAR EXHAUST PIPE>REMOVAL .
- Remove the inhibitor cover. (Crosstrek hybrid model)
- Disconnect the select cable from the transmission main body.CAUTION: Do not apply excessive load while holding the part (a).
- Lower the vehicle, and remove the select lever assembly from the room side.NOTE: Pass the select cable from the underside of the vehicle to the room side.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
