2023 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

Transmission Case: Disassembly

  1. Remove all plugs.
    G13200235Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the lubrication pipe.
    G13622231Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the O-rings.
    G13622232Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the snap ring on the primary pulley side.
    G13622233Courtesy of SUBARU OF AMERICA, INC.
  5. Using the ST, remove the roller bearing.

    Preparation tool:Β 

    ST: PULLER ASSY (398527700)

    G13622234Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the spacer.
    G13622235Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the snap ring on the secondary pulley side.
    G13622236Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the roller bearing using the ST1 and ST2.

    Preparation tool:Β 

    ST1: PULLER ASSY (398527700)

    ST2: CLAW (18760AA000)

    G14611402Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the ball bearing on the reduction driven gear side using ST.

    Preparation tool:Β 

    ST: PULLER ASSY (398527700)

    G13622238Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.