2023 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

Transmission Case

Fig 1: Transmission Case Components Location
G16440236Courtesy of SUBARU OF AMERICA, INC.
(1) Snap ring
(2) Roller bearing
(3) Seal ring
(4) Spacer
(5) Oil seal
(6) Gasket
(7) Filler plug (for overhaul)
(8) Plug
(9) O-ring
(10) Plug
(11) O-ring
(12) Test plug (line pressure)
(13) O-ring
(14) Straight pin
(16) Pitching stopper plate
(15) Ground cord
(17) Seal ring
(18) Ball bearing
(19) Transmission case
(20) O-ring
(21) Plug
(22) Gasket
(23) Union bolt
(24) Union bolt
(25) CVTF cooler outlet pipe
(26) CVTF cooler inlet pipe (model without CVTF cooler (air cool))
(27) CVTF cooler inlet pipe (model with CVTF cooler (air cool))
(28) Plug
(29) O-ring
(30) Roller bearing
(31) Snap ring
(32) Lubrication pipe
(33) O-ring

Tightening torque: N.m (kgf-m, ft-lb) 

T1: 7 (0.7, 5.2) 

T2: 13 (1.3, 9.6) 

T3: 16 (1.6, 11.8) 

T4: 18 (1.8, 13.3) 

T5: 25 (2.5, 18.4) 

T6: 32.3 (3.3, 23.8) 

T7: 35 (3.6, 25.8) 

T8: 40 (4.1, 29.5) 

T9: 50 (5.1, 36.9) 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.