Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE
MULTIVIEW Control Module
- Install the multiview control assembly.
- Install the cockpit control module. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY>ASSEMBLY .
- Install the grille ventilation assembly center. Ref. to AIR CONDITIONER>AIR VENT GRILLE>INSTALLATION>CENTER GRILLE ASSEMBLY .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- When the multiview control assembly has been replaced with a new part, perform the data transfer.
- Using the Subaru Select Monitor, select [Carrying over Calibration data when replacing the Camera ECU] in [Work Support] of [Front & Side Camera/Multi View Monitor]. Ref. to COMMON (DIAGNOSTICS)>WORK SUPPORT>OPERATION .
- Perform the operation according to the display screen.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.