Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Front Strut: Installation
CAUTION:
For parts which are not reusable, always use new parts.
- Install the mount strut front at the upper side of the strut assembly to the vehicle body.
Tightening torque:
32 N.m (3.3 kgf-m, 23.6 ft-lb)
- Align alignment marks on the adjusting bolt and the strut assembly, and install the strut assembly to the front axle housing.CAUTION:
- While holding the bolt side, tighten the nut to the specified torque.
- Do not forget to install the adjusting washer.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.