Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Reset The Full Close Stop Position
When the full close stop position becomes misaligned, it can be reset by performing the following procedure.
- Turn the ignition switch to ON.
- Operate and hold the switch - power window in "AUTO UP" direction (fully pull up the switch) for three seconds or more.NOTE:
For the driver's side window, this operation can be done from the switch - power window main, and for the passenger's and the rear seat side window, this can be done from either the switch - power window main or the switch - power window on the passenger's side or the rear seat side.
- Check that the glass starts rolling up and fully closes.
- Operate the switch - power window in "AUTO DOWN" direction to check whether the window fully opens properly.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.