2022 Subaru Legacy BaseFACTORY OEM SERVICE PROCEDURE

Select Lever: Removal

NOTE:
  • The shift lock solenoid, "P range" switch and manual mode switch are integrated with the select lever.
  • The select lever cannot be disassembled.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the mat center tray.
    G13620985Courtesy of SUBARU OF AMERICA, INC.
  3. Release the shift lock using a screwdriver, etc. and shift the select lever to the "N range".
    G13620986Courtesy of SUBARU OF AMERICA, INC.
  4. Lower the section (A) of the boot.
    G13621448Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the clamp (A) and remove the grip.
    G13621449Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the boot.
    G13621450Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the cover center side RH and the cover center side LH. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CONSOLE>REMOVAL
  8. Remove the duct console center. (Models with rear seat air conditioning) Ref. to REMOVAL .
  9. Remove the select cable. Ref. to CONTROL SYSTEMS>SELECT CABLE>REMOVAL .
  10. Disconnect the connector.
    G13621451Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the clip securing the harness, and remove the select lever.
    • Model without CD deck
    G13621454Courtesy of SUBARU OF AMERICA, INC.
    • Model with CD deck
    G13621453Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the bolts which secure the select lever.
    G13621452Courtesy of SUBARU OF AMERICA, INC.
  13. Remove the select cable from the select lever. Ref. to CONTROL SYSTEMS>SELECT CABLE>REMOVAL 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.