Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Mode B
| DTC | Description and trouble part | Condition | Number of driving cycles on the detecting condition |
|---|---|---|---|
| P0087 | FUEL RAIL/SYSTEM PRESSURE - TOO LOW BANK 1 | Complete diagnosis with inspection mode A as well. | 1 |
| P0088 | FUEL RAIL/SYSTEM PRESSURE - TOO HIGH BANK 1 | Complete diagnosis with inspection mode A as well. | 1 |
| P0134 | A/F/O2 SENSOR CIRCUIT NO ACTIVITY DETECTED BANK 1 SENSOR 1 | - | 1 |
| P0137 | O2 SENSOR CIRCUIT LOW VOLTAGE BANK 1 SENSOR 2 | - | 2 |
| P0138 | O2 SENSOR CIRCUIT HIGH VOLTAGE BANK 1 SENSOR 2 | - | 2 |
| P0140 | O2 SENSOR CIRCUIT NO ACTIVITY DETECTED BANK 1 SENSOR 2 | - | 2 |
| P0171 | SYSTEM TOO LEAN BANK 1 | Complete diagnosis with inspection mode A as well. | 2 |
| P0172 | SYSTEM TOO RICH BANK 1 | Complete diagnosis with inspection mode A as well. | 2 |
| P0300 | RANDOM/MULTIPLE CYLINDER MISFIRE DETECTED | Complete diagnosis with inspection mode A as well. | 2 |
| P0301 | CYLINDER 1 MISFIRE DETECTED | Complete diagnosis with inspection mode A as well. | 2 |
| P0302 | CYLINDER 2 MISFIRE DETECTED | Complete diagnosis with inspection mode A as well. | 2 |
| P0303 | CYLINDER 3 MISFIRE DETECTED | Complete diagnosis with inspection mode A as well. | 2 |
| P0304 | CYLINDER 4 MISFIRE DETECTED | Complete diagnosis with inspection mode A as well. | 2 |
| P0500 | VEHICLE SPEED SENSOR "A" CIRCUIT | - | 1 |
| P0506 | IDLE CONTROL SYSTEM RPM - LOWER THAN EXPECTED | - | 2 |
| P0507 | IDLE CONTROL SYSTEM RPM - HIGHER THAN EXPECTED | - | 2 |
| P059F | ACTIVE GRILLE AIR SHUTTER "A" PERFORMANCE/STUCK OFF | [Ambient Temperature]: 3 - 33°C (37.4 - 91.4°F) | 2 |
| P05A0 | ACTIVE GRILLE AIR SHUTTER "A" STUCK ON | 2 | |
| P05A1 | ACTIVE GRILLE AIR SHUTTER "A" POSITION SENSOR MINIMUM/MAXIMUM STOP PERFORMANCE | 2 | |
| P05A2 | ACTIVE GRILLE AIR SHUTTER "A" CONTROL CIRCUIT/OPEN | 1 | |
| P05A6 | ACTIVE GRILLE AIR SHUTTER "A" SUPPLY VOLTAGE CIRCUIT/OPEN | 1 | |
| P05C0 | ACTIVE GRILLE AIR SHUTTER MODULE "A" OVER TEMPERATURE | 1 | |
| P062D | FUEL INJECTOR DRIVER CIRCUIT PERFORMANCE BANK 1 | - | 1 |
| P0851 | PARK/NEUTRAL SWITCH INPUT CIRCUIT LOW | - | 2 |
| P0852 | PARK/NEUTRAL SWITCH INPUT CIRCUIT HIGH | - | 2 |
| P1261 | CYLINDER 1 DIRECT FUEL INJECTOR CIRCUIT/OPEN | - | 1 |
| P1262 | CYLINDER 2 DIRECT FUEL INJECTOR CIRCUIT/OPEN | - | 1 |
| P1263 | CYLINDER 3 DIRECT FUEL INJECTOR CIRCUIT/OPEN | - | 1 |
| P1264 | CYLINDER 4 DIRECT FUEL INJECTOR CIRCUIT/OPEN | - | 1 |
| P162A | STARTER INTERLOCK INTERNAL CIRCUIT | - | 1 |
| P2096 | POST CATALYST FUEL TRIM SYSTEM TOO LEAN BANK 1 | Complete diagnosis with inspection mode A as well. | 2 |
| P2097 | POST CATALYST FUEL TRIM SYSTEM TOO RICH BANK 1 | Complete diagnosis with inspection mode A as well. | 2 |
When performing inspection mode B on a public road, pay sufficient attention to the traffic condition and give the highest priority to safe driving.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.