Name: AllOEMManuals
Address: 316 Brandywine Ave, Streetman, TX, 75859, US
Telephone: +14699867883
Price range: $$

NOTE:

The readiness code shows self-diagnosis status of each DTC. The DTCs displayed here are either not yet self-diagnosed or self-diagnosed but not completed. After the self-diagnosis is complete, DTC will no longer be displayed regardless of the diagnostic result.
Self-diagnosis is executed every time when the ignition switch is turned to ON. Therefore, even after the self-diagnosis is complete and nothing is displayed on the readiness code display, if you turn the ignition switch to ON again after turning it OFF, some DTCs may be displayed on the readiness code display.
After you repair a DTC and perform the inspection mode, use the readiness code to check if the self-diagnosis of the DTC is completed. If the concerned DTC is displayed, the self-diagnosis of the DTC is not complete. Perform the inspection mode again.
For detailed operation procedures, refer to "Help" of application.

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, input the target vehicle information and select [OK].
On [Main Menu] screen, select [Each System].
On [Select System] screen, select [Engine Control System], and then select [Next].
On [Select Function] screen, select [DTC].
On [DTC] screen, select [All Readiness Diagnostic Code(s)].

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

All Readiness Diagnostic Code(s): Operation