Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE
Fuel Insulator: Installation
- Install the fuel pipe insulator.CAUTION:
- If substantial amount of fuel or parts cleaner come into contact with the fuel pipe insulator, replace it with a new fuel pipe insulator.
- If only small amount of fuel comes into contact with the fuel pipe insulator, wait for the fuel to evaporate before installing it.
- Secure the engine wiring harness with the bolts.
Tightening torque:
6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
- Install the clip securing the engine wiring harness.
- Connect the connector to the outlet engine coolant temperature sensor.
- Install the intake manifold assembly. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>INTAKE MANIFOLD ASSEMBLY>INSTALLATION .
- Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO)>AIR INTAKE BOOT>INSTALLATION .
- Install the collector cover. Ref. to INTAKE (INDUCTION) (H4DO)>COLLECTOR COVER>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.