2022 Subaru Crosstrek Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE

Select Cable: Installation

CAUTION:
  • Check that the protector (b) is set between the clamps (a). 
  • If the protector (b) is offset, set it between the clamps (a). 
G13935596Courtesy of SUBARU OF AMERICA, INC.
  1. Install the select cable to cable plate.
    CAUTION:

    Be careful not to twist the boot. 

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb)

    G13225512Courtesy of SUBARU OF AMERICA, INC.
  2. Set a new clamp on the select lever and secure it by bending the claw.
    NOTE:

    Set so that the claw faces toward the rear side. 

  3. Insert the select cable into the select lever and secure it with the clamp.
    CAUTION:

    Do not apply excessive load while holding the part (a). 

    G13591854Courtesy of SUBARU OF AMERICA, INC.
    G08550615Courtesy of SUBARU OF AMERICA, INC.
  4. Temporarily Install the adjusting nut to the select cable.
  5. Connect the select cable to the transmission main body.
    CAUTION:

    Do not apply excessive load while holding the part (a). 

    G13591814Courtesy of SUBARU OF AMERICA, INC.
Chapter Navigation
Return to Chapter: Select Cable
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.