Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2022 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE

Engine Control System (Diagnostics - Introduction): Electrical Component Location: Location: Body

Courtesy of SUBARU OF AMERICA, INC.

(1)	Canister
(2)	Fuel pump
(3)	Combination meter
(4)	Push button ignition switch
(5)	Battery sensor
(6)	Mass air flow and intake air temperature sensor
(7)	Engine control module (ECM)
(8)	M/B
(9)	Accelerator pedal position sensor
(10)	Data link connector
(11)	Leak check valve ASSY

Chapter Navigation

Return to Chapter: Location

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.