Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE
Fuel Pump Assembly: Specification
CAUTION:
Harness routing differs depending on the type of fuel pump assembly. Be sure to install the fuel level sensor and connector cable that match the type.
- A-type
Fuel level sensor harness length: L1 Approx. 225 mm (8.86 in) Connector cable harness length: L2 Approx. 200 mm (7.87 in) - B-type
Fuel level sensor harness length: L1 Approx. 314 mm (12.36 in) Connector cable harness length: L2 Approx. 250 mm (9.84 in)
| (A) | A-type |
| (B) | B-type |
| (C) | Clip |
| (D) | Fuel level sensor |
| (E) | Connector cable |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.