Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
At Learning Mode
- On [Start] screen, select [Diagnosis].
- On [Vehicle selection] screen, enter vehicle information and select [Set].
- On [Main Menu] screen, select [Each System].
- On [Select System] screen, select [Transmission Control System].
- On [Select Function] screen, select [Work Support].
- On [Work Support] screen, select [AT learning mode].
- Follow the messages displayed on the screen when working.
- When [AT learning normally ended.] is displayed, AT learning mode is completed.NOTE:
- If communication error occurs during learning, retry the "AT learning mode" from the beginning.
- If the message [Execute AT learning again after fixing troubles of the vehicle] is displayed during learning, select [OK] to display the List of Diagnostics Trouble Code.
After repairing the locations indicated by the DTC, start the "AT learning mode" over from the beginning.
- When communication error occurs during learning, select lever does not shift occasionally. If select lever does not shift, turn the ignition switch to OFF before operating the select lever.
- If the message [AT learning ended abnormally. Try again from the beginning.] is displayed, start the "AT learning mode" over from the beginning.
Display Main causes for abnormal termination [AT learning ended abnormally. Try again from the beginning.] - Fault is detected during AT learning.
- The accelerator pedal is depressed during AT learning.
- An unspecified operation was performed during AT learning
- ATF temperature becomes out of specification during AT learning.
- Battery voltage is low.
- The malfunction indicator light is lit.
- Parking brake is not applied hard enough.
- Brake pedal is not fully depressed.
- Abnormal idle speed increase, etc.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.