2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

M/T Clutch System: Flywheel: Inspection

CAUTION: Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.
  1. If there is damage or defectiveness in the facing sliding surface or ring gear, replace the flywheel.
    G13646983Courtesy of SUBARU OF AMERICA, INC.
  2. Smoothness of rotation

    Rotate the ball bearing while applying pressure in the thrust direction.

  3. If any noise or excessive play is noted, replace the pilot bearing.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.