2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Front Crossmember Support Plate: Installation

CAUTION: Install the under cover - front so that the front end of the under cover (b) comes inside the bumper face - front (a).
G10269429Courtesy of SUBARU OF AMERICA, INC.
  1. Install the front crossmember support and the support plate - front crossmember.

    Tightening torque:Β 

    Refer to "COMPONENT" of "General Description" for the tightening torque. Refer to FRONT SUSPENSION>GENERAL DESCRIPTION>COMPONENTΒ .

  2. Install the under cover - front. Refer to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>INSTALLATION .
  3. Lower the vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.