Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Timing Belt: Removal: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
- When replacing a single part, perform the work with the engine assembly installed to body.
- When performing the work with the engine installed to body, the following parts must also be removed/installed.
- Radiator main fan motor assembly. Refer to COOLING(STI)>RADIATOR MAIN FAN AND FAN MOTOR>REMOVAL . Refer to COOLING(STI)>RADIATOR MAIN FAN AND FAN MOTOR>INSTALLATION .
- Radiator sub fan motor assembly Refer to COOLING(STI)>RADIATOR SUB FAN AND FAN MOTOR>REMOVAL . Refer to COOLING(STI)>RADIATOR SUB FAN AND FAN MOTOR>INSTALLATION .
- When performing the work with the engine installed to body, protect the radiator with cardboards or blankets.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
