Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Method With Timing Light
WARNING: This page is about a different variant/trim than selected.
- Before checking the ignition timing, check the following item:
- Check the air cleaner element is free from clogging, spark plugs are in good condition, and hoses are connected properly.
- Check the malfunction indicator light does not illuminate.
- Warm up the engine.
- Stop the engine, and turn the ignition switch to OFF.
- Disconnect the ground cable from battery.
- Remove the air intake duct. Refer to INTAKE (INDUCTION) (STI)>AIR INTAKE DUCT>REMOVAL .
- Remove the air cleaner case. Refer to INTAKE (INDUCTION) (STI)>AIR CLEANER CASE>REMOVAL .
- Connect the timing light to the power wire of #1 ignition coil.
- Install the air cleaner case. Refer to INTAKE (INDUCTION) (STI)>AIR CLEANER CASE>INSTALLATION .
- Connect the battery ground terminal.
- Start the engine, turn the timing light to the crank pulley, and check the ignition timing through the timing belt cover gauge.NOTE: If ignition timing is out of standard, check the ignition control system. Refer to "Engine Control System". Refer to ENGINE (DIAGNOSTICS) (STI)>BASIC DIAGNOSTIC PROCEDURE .
Ignition timing [BTDC/{r/min}]:
Standard
15°±10°/700
- After inspection, install the related parts in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
