2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Method With SUBARU Select Monitor

WARNING: This page is about a different variant/trim than selected.
  1. Before checking the ignition timing, check the following item:
    1. Check the air cleaner element is free from clogging, spark plugs are in good condition, and hoses are connected properly.
    2. Check the malfunction indicator light does not illuminate.
  2. Warm up the engine.
  3. Read the ignition timing using Subaru Select Monitor. Refer to ENGINE (DIAGNOSTICS) (STI)>SUBARU SELECT MONITOR>OPERATION>DISPLAY CURRENT ENGINE DATA (NORMAL MODE) .
    NOTE: If ignition timing is out of standard, check the ignition control system. Refer to "Engine Control System". Refer to ENGINE (DIAGNOSTICS) (STI)>BASIC DIAGNOSTIC PROCEDURE .

    Ignition timing [BTDC/{r/min}]: 

    Standard 

    15°±10°/700

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.