2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Cylinder Block

WARNING: This page is about a different variant/trim than selected.
Fig 1: Cylinder Block Components (With Torque Specification)
G13640439Courtesy of SUBARU OF AMERICA, INC.

Tightening torque: N.m (kgf-m, ft-lb) 

T1: 5 (0.5, 3.7) 

T2: 6.4 (0.7, 4.7) 

T3: 10 (1.0, 7.4) 

T4: First 12 (1.2, 8.9) 

Second 12 (1.2, 8.9) 

T5: 16 (1.6, 11.8) 

T6: 25 (2.5, 18.4) 

T7: 46.5 (4.7, 34.3) 

T8: 54 (5.5, 39.8) 

T9: 69 (7.0, 50.9) 

T10: 70 (7.1, 51.6) 

T11:  Refer to MECHANICAL(STI)>CYLINDER BLOCK>INSTALLATION .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.