2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Transmission Control Module (TCM) I/O Signal: Waveform: Solenoid

WARNING: This page is about a different variant/trim than selected.
G11270814Courtesy of SUBARU OF AMERICA, INC.
G11270815Courtesy of SUBARU OF AMERICA, INC.
G11270816Courtesy of SUBARU OF AMERICA, INC.
G11270817Courtesy of SUBARU OF AMERICA, INC.
G11270818Courtesy of SUBARU OF AMERICA, INC.
G11257602Courtesy of SUBARU OF AMERICA, INC.
G11270820Courtesy of SUBARU OF AMERICA, INC.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.