Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Section 19 (Engine Control System (Diagnostics) (2.5L) (3 Of 4))
WARNING: This page is about a different variant/trim than selected.
- Diagnostic Procedure with Diagnostic Trouble Code (DTC)
- DTC P081A: Starter Disable Circuit Low
- DTC P0851: Park/Neutral Switch Input Circuit Low
- DTC P0852: Park/Neutral Switch Input Circuit High
- DTC P1160: Throttle Return Spring
- DTC P1410: Secondary Air Injection System Combination Valve Stuck Open
- DTC P1449: EVAP System Clog Detected (Air Filter)
- DTC P1451: EVAP System Clog Detected (Pipe)
- DTC P2004: TGV Control Stuck Open Bank 1
- DTC P2005: TGV Control Stuck Open Bank 2
- DTC P2006: TGV Control Stuck Closed Bank 1
- DTC P2007: TGV Control Stuck Closed Bank 2
- DTC P2008: TGV Control Circuit/Open Bank 1
- DTC P2009: TGV Control Circuit Low Bank 1
- DTC P2011: TGV Control Circuit/Open Bank 2
- DTC P2012: TGV Control Circuit Low Bank 2
- DTC P2016: TGV Position Sensor/Switch Circuit Low Bank 1
- DTC P2017: TGV Position Sensor/Switch Circuit High Bank 1
- DTC P2021: TGV Position Sensor/Switch Circuit Low Bank 2
- DTC P2022: TGV Position Sensor/Switch Circuit High Bank 2
- DTC P2088: "A" Camshaft Position Actuator Control Circuit Low Bank 1
- DTC P2089: "A" Camshaft Position Actuator Control Circuit High Bank 1
- DTC P2090: "B" Camshaft Position Actuator Control Circuit Low Bank 1
- DTC P2091: "B" Camshaft Position Actuator Control Circuit High Bank 1
- DTC P2092: "A" Camshaft Position Actuator Control Circuit Low Bank 2
- DTC P2093: "A" Camshaft Position Actuator Control Circuit High Bank 2
- DTC P2094: "B" Camshaft Position Actuator Control Circuit Low Bank 2
- DTC P2095: "B" Camshaft Position Actuator Control Circuit High Bank 2
- DTC P2096: Post Catalyst Fuel Trim System Too Lean Bank 1
- DTC P2097: Post Catalyst Fuel Trim System Too Rich Bank 1
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
