2021 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

LH Side

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery. Refer to STARTING/CHARGING SYSTEMS(STI)>BATTERY>REMOVAL .
  2. Remove the secondary air pump. Refer to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (STI)>SECONDARY AIR PUMP>REMOVAL .
  3. Remove the bolts that secure the air duct to the rocker cover LH, and lift the air duct.
    G06333842Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the connector from ignition coil.
    CAUTION: Be careful not to damage the claw (a) of the connector.
    G11574057Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the ignition coil.
    NOTE: Turn #4 ignition coil by 180Β° to remove it.
    G08539623Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the spark plug with a spark plug socket.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.