Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Radiator Cap: Inspection
- Check that the radiator cap does not have deformation, cracks or damage.
- Attach the radiator cap tester to radiator cap.
- Increase pressure until the radiator cap tester gauge needle stops. Radiator cap is functioning properly if it holds the service limit pressure for 5 - 6 seconds. Replace the radiator cap if its valve opens at less than the service limit.
- Be sure to remove foreign matter and rust from the cap in advance. Otherwise, results of pressure test will be incorrect.
- Do not confuse the cap of coolant filler tank and cap of radiator.
Coolant filler tank side:Â
StandardÂ
93 - 123 kPa (0.95 - 1.25 kg/cm2 , 14 - 18 psi)
LimitÂ
83 kPa (0.85 kg/cm2 , 12 psi)
Radiator side:Â
StandardÂ
122 - 152 kPa (1.24 - 1.55 kg/cm2 , 18 - 22 psi)
LimitÂ
112 kPa (1.14 kg/cm2 , 16 psi)
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
